Regional focusWater, energy and MEP integrated over the same territory: Los Cabos, BCS.
Four fronts under one technical direction, from feasibility to commissioning — for residential, tourism-hospitality, industrial and urban projects.
Drawing on its technical director's track record in the region — CFE, CONAGUA, electrical supply and MEP engineering — EXERGÍA sees recurring patterns in how infrastructure projects are planned and executed in Los Cabos.
Hydraulic and electrical design are usually split between different firms, with no single technical direction integrating them from the pre-project stage.
01 / 03CFE (SIGLA V2, SISPROTER, DEPRORED) and CONAGUA procedures usually start after design is finished, when adjusting the project to the agency's requirements already costs more.
02 / 03Without a technical direction coordinating them, each provider (BIM, submetering, power quality) works in isolation and the project loses value engineering.
03 / 03
Design and feasibility for potable water networks, sanitary and storm drainage, desalination and wastewater treatment plants, and deep well drilling — with CONAGUA permitting built into the same process.
With pumping and flow tests under CONAGUA's Book 40 methodology, and in-situ water quality testing (pH, conductivity, salinity, TDS, dissolved oxygen) that supports the design.
One technical point of contact between hydraulic design and the CONAGUA concession process.
Medium and low voltage networks, service connections and private substations, photovoltaic systems and microgrids with storage — from pre-project to commissioning.
By integrating photovoltaic, utility grid, BESS and gas generation into one microgrid scheme, with electrical calculation memos under CFE specification.
Less dependence on a single supply source, with documented preventive and corrective maintenance.
Design and execution of electrical, plumbing and LP gas installations, HVAC and CCTV, with contract administration of subcontractors through commissioning.
With single-line diagrams, load schedules and as-built projects, plus direct coordination of quantities and unit prices with each subcontractor.
One technical direction follows the build from drawing to commissioning, without losing traceability.
Permitting before CFE (SIGLA V2, SISPROTER, DEPRORED) and CONAGUA, technical-financial feasibility studies, and coordination of specialists, contractors and suppliers under one technical direction.
With BIM collaboration on the Autodesk ACC/Forma platform, bringing investors, specialists and site teams into a single project model.
Regulatory permitting is planned from design, not handled afterward as a correction.